The effect
The as Airflame system is a gas flame simulation device with variable flame column height, reaching up to 8 metres. The effect can be repeated without recharging.

The substances required for the effect, lycopodium or Airflame powder, are not flammable themselves. That is why there are no restrictions on storage and transport.

No pyrotechnical ignition means are required. The device merely requires connection to a compressed air supply.

Specifications
Mains power supply: 230 V/16 , 50Hz
Air compressor: 200 litres/minute
4-channel control unit in 19" rack
4 firing units can be connected
Connection lines and hoses: every 15 metres

Availability
For temporary use, the device is available to rent from as systems.

 

The effect
Propane gas Flames can reach a height of 3 metres and a burning time of approx. 7 seconds. The flame height is regulated using a pressure reducer on the flame projector. The effect duration is adjusted using a step switch on the control device. Micro-processor-controlled ignition and flame monitoring ensure top operational safety of gas flame projectors. They can be controlled by DMX and remote control.


Specifications

Control and monitoring device, micro-processor-controlled for
- activating the flame projector by pushbutton, remote control or DMX
- setting the flame duration
- safety cut-off in case of malfunction
Dimensions: approx. 31 x 33 x 8.5cm
Flame projector for connection to a 11.5kg propane gas cylinder
- Pressure reducer for height regulation of the effect
Dimensions: approx. 22 x 40 x 17cm

Availability
as systems sells new devices and supplies rental devices for temporary use.